Universal smart charger for rechargeable batteries, VRLA, AGM, VLA, SLA, WET, GEL, LEAD ACID , capacity from 1.2 Ah to 120 Ah. Automatically determines the type and battery voltage 6 V or 12 V DC. The device is controlled by mikroprocesorowo. Maximum charging current is equal to 3.8 A. The charger constantly monitors the battery voltage when fully charged and goes into a maintenance mode, in case of detection of the voltage drop starts again the charging process. Very useful functions are also automatic odsiarczanie and reactivation is extremely low batteries. There is also a mode "winter" , which allows to charge batteries in very low temperature environment.
Specification:
- Power supply: from 220 V to 240 V / 50-60 Hz (AC)
- Automatic detection of batteries of 6 V or 12 V
- Supported battery types: VRLA, AGM, VLA, SLA, WET, GEL, LEAD-ACID
- Supported battery capacity:
- For batteries 12V, from 1.2 Ah to 120 Ah
- For 6 V batteries from 1.2 Ah to 14 Ah
- Charge voltage:
- For 12-volt batteries: approx. 14.4 V
- Battery 6 V: approx. 7,3 V
- Efficiency: 75% to 80 %
- Charging current: 0.8 A or 3.8 A
- Working temperature: from -10 °C to 40 °C
- Monitoring voltage at the end charging
- Winter mode: allows you to charge at low ambient temperatures
- Mode of reactivation / resuscitation for extremely discharged batteries
- Led signal
- Dimensions: 183 x 68 x 47 mm
- Weight: 532 g
Mileage smart charging:
PHASE 1: DIAGNOSTICS: analysis of the battery, its charge and that all connections are correct between the battery and charger
STEP 2: ODSIARCZANIE: zasiarczonego diagnostics battery, charging and pulsed current with low voltage and high amperage used to remove sulphate from the plates of the battery, thereby will be restored to its original capacity
STEP 3: SOFT START: to check whether the battery is not damaged and if it can accept charge current (prevents the download of corrupted accumulator); in the case that the battery is not damaged starts charging, gradually increasing the strength of the current charging
STEP 4: LOAD MAIN: charging with maximum current with a constant voltage value adjustable automatically depending on the battery status, the time of achievement of 80% of battery capacity
STEP 5: DOWNLOAD ULTIMATE: charging current of decreasing intensity and a constant voltage until reaching 100% battery capacity
STAGE 6: ANALYSIS: continuing about 2 minutes to check the battery – if after you stop charging, the charge level of the battery falls, the charging process is completed
STEP 7: SAVE: save battery power at the maximum level using the charge current with constant voltage
STEP 8: FLASHING: the battery voltage monitoring and maintaining the optimal charge of the battery at 95-100% capacity using current pulses charging