DFRobot Gravity pH analog sensor / meter Pro V2

Brand: Dfrobot
Product Code: AN-17652
Availability: Vilnius Store Out of Stock
Kaunas Store Out of Stock
Central Warehouse In Stock
80.80€
Ex Tax: 66.78€

Qty

Analog pH Pro V2 sensor enables the measurement of solution pH, acidity or alkalinity. It is equipped with an industrial electrode with a long life and simple connection to the module. The sensor can measure pH in the range from 0 to 14 and is powered from 3.3 V to 5.5 V.

Note:
  • The BNC connector and the signal conversion module must not get wet. Moisture may cause inaccurate measurements
  • The signal conversion module must not be placed on a damp surface, otherwise it will affect the output impedance, causing inaccurate measurement
  • The glass part of the electrode should not touch hard material. Any damage or scratches will damage the electrode
  • After the measurement is completed, disconnect the probe from the module. The electrode should not be connected to the module for a long time without power
Specification:
  • Signal conversion module:
    • Supply voltage: from 3.3 V to 5.5 V
    • Output voltage: 0 V to 3 V
    • Probe connector: BNC
    • Output connector: Gravity PH2.0, 3 pin
    • Measurement accuracy: ±0.1 at 25 °C
  • PH probe:
    • Probe type: industrial
    • Detection range: 0 pH to 14 pH
    • Temperature range: 0 °C to 60 °C
    • Accuracy: ±0.1 pH at 25 °C
    • Response time: up to 1 min
    • Probe life: 7 x 24 h over 0.5 years (depending on water quality)
    • Cable length: 500 cm
Shipping list:
  • Gravity cable x1
  • Waterproof gasket x2
  • BNC nut x1
  • Nylon spacer M3 x 10 mm x4
  • Screw M3 x 5 mm x8