DC/DC voltage converter LM2596 from 3-35V to 1.5-30V 3A (STEP DOWN)

Brand: OpenPlatform
Product Code: AN0362
Availability: 5-8 business days
Planuojama gavimo data po užsakymo: 2025-04-18
3.40€
Ex Tax: 2.81€

Qty

LM2596 converter that steps down the voltage from 3V to 35V to a potentiometer adjustable voltage from 1.5V to 30V.

This device allows you to safely, stably supply electronics, FPV (cameras, etc.) using a stabilized constant DC voltage.

Thanks to it, we can get a lower voltage from the higher voltage required to power the device, commonly used in monitors, televisions and other small electronics. We also offer LM2596 main modules in TO-263-5 or TO-220 packages, as well as chokes to create a complete power system.


Features:

  • Convenient adjustment of the output voltage using a multi-turn potentiometer.
  • The converter has protection against short circuit and excessive current, thanks to which a current greater than 3 A will not appear in the receiver.
  • The converter allows systems to be powered at a lower than standard voltage.
  • The converter is based on the proven and frequently used LM2596 system

Specifications:

  • Input voltage: 3-35V
  • Adjustable output voltage: 1.5-30V
  • Converter chip: LM2596
  • Output current: 2A constant, Max 3A (with radiator), the radiator must be turned on when the power exceeds 15W. (radiator not included)
  • Efficiency: max. 92%
  • Frequency: 150 kHz
  • Operating temperature: -40 ℃ to +85 ℃ (power at 10W)
  • Short circuit protection: current limit, Auto-CV
  • Weight: 11.7g
  • Dimensions: 47x23x14mm

Notes:

  • The device regulates the voltage by lowering it (does not raise the voltage). The supply voltage must be higher than the receiving voltage.
  • Incorrect polarity of the power supply will damage the inverter
  • This device is intended for experienced DIY enthusiasts, basic electronics knowledge and soldering skills are required. The company is not responsible for damage caused by lack of soldering skills or poor electrical installation.
  • Check the output voltage and adjust it with the appropriate potentiometer and only then connect the receiving device.